Configuring The Input And Output For A Camera; Configuring The Sequences; Creating A Sequence - Honeywell MAXPRO NVR XE Operator's Manual

C O N F I G U R I N G M A X P R O N V R
3
C
O NF IG U R IN G T H E IN P U T A ND O U T P U T F OR A C A M E R A
Almost all the IP cameras have one or more input and output slots that can be configured. For
example, you can configure an input of a camera to a motion detected sensor and output of a
camera to a door. In this example, if a motion is detected by the camera, the door
automatically opens.
In MAXPRO NVR, the inputs and outputs of a camera are configured by default in the
database while adding a camera. MAXPRO NVR has a specialized interface that lists the
inputs and outputs associated to the configured cameras. Camera output is also referred to as
Relay (an output contact that can be triggered from MAXPRO NVR. Relays can be connected
to devices like cameras. Relays send signals that perform various actions).
To configure input and output
1.
2.
3.
4.
5.
6.
C
O NF IG U R IN G T H E S E Q U E N C E S
A sequence is a set of live video streamed one after the other from cameras for a specified
time interval. You can select the cameras or presets to be included in a sequence and also
specify the time interval for which the video from each camera or preset must be displayed.
Note:
C
REATING A SEQUENCE
You can create a sequence to display video that is captured from different cameras connected
to MAXPRO NVR.
Note:
To create a sequence
1.
2.
3.
4.
44
Click the Configurator tab. The System page displays by default.
Click the I/O tab to open the I/O page.
The Input(s) pane lists the inputs for the configured cameras.
The Output(s) pane lists the outputs for the configured cameras.
In the Output(s) pane, select a output and then click On to turn on the relay manually or
Click Off to turn off the relay manually.
Click Save or click Reset to undo the changes.
Presets must be defined for the cameras before including them in the sequence
You can add a maximum of 50 sequences in MAXPRO NVR.
Click the Configurator tab. The System page displays by default.
Click the Sequence tab to navigate to the Sequence page.
Click Add.
Under Details
• The Sequence Name appears by default. You can type a new Sequence Name as
applicable.
MAXPRO NVR Operator's Guide