Installation Steps; Unpacking The Backup Subsystem - Fujitsu FibreCAT TXF Operating Manual

Installation steps

3.1 Installation steps
Ê Unpacking the backup subsystem (see next
subsystem").
Ê Mount the backup subsystem in the rack (see
the backup subsystem in the rack" on page
Ê If SCSI model: Set the SCSI bus addresses of the installed backup devices
(see section "Connecting SCSI cables" on page
Ê Connect the cables to the backup subsystem according to the desired (rack)
configuration.
Ê Connect the backup subsystem to the mains voltage (see
"Connecting the power cord" on page
Ê Start up the backup subsystem (see
page 39).
3.2

Unpacking the backup subsystem

V
CAUTION!
Please note the safety instructions in
page 11
If you need to lift or transport the backup subsystem, ask someone to
help you.
You should retain the original packaging of the backup subsystem for possible
further transport.
Ê Unpack all individual parts.
Ê Check the delivery for any damage during transport.
Ê Check whether the items delivered match the details on the delivery note.
Ê Check whether the first page of the guarantee booklet has been completed
in full.
Notify your supplier immediately should you discover that the items delivered do
not correspond to the delivery note.
20
section "Unpacking the backup
21).
35).
chapter "Starting up and operation" on
chapter "Important information" on
Operating Manual
section "Installing/removing
36).
section
FibreCAT TXF
Installation