Installation
Installation in the PRIMECENTER Rack or DataCenter Rack
3.5.2
Telescopic rail variant
When mounting the left telescopic rail in the PRIMECENTER/DataCenter Rack,
the supplied support bracket must first be mounted on the rear left support
upright flush with the bottom edge of the device.
2
1
Figure 10: Fitting the support bracket
Ê Position the support bracket at the corresponding height on the rear left
support upright, (insert lug in corresponding hole) (1).
Ê Secure the bracket with two screws incl. plug washers (2).
2
1
Figure 11: Removing the carrier rail
Ê Extend the telescopic rail fully (1).
Ê Press the locking lever to release the carrier rail (2).
Ê Remove the carrier rail.
Ê Repeat the last three steps with the second telescopic rail.
Operating Manual
29
FibreCAT TXF