Digital Video Configuration-Video Ir And Video Dltv; Analog Video Configuration-Video Matrix - FLIR PT-Series Installation Manual

PT-Series Installation Manual
2.4.3 Digital Video Configuration—Video IR and Video DLTV
Note
When defining the ports for digital video, streams are setup sequentially; 0, 1, 2, and 3. If a
stream is enabled, the server will use the RTP/RTSP over HTTP port parameter to define the
port number (if left blank, 8080 is used). A subsequent stream's configuration takes
precedence so the same port needs to be defined for all enabled video streams. (But actually
you could really only define a non-default port for the last video stream configured.)
Step 1 Click Video IR. The screen at the right
will be displayed.
Step 2 Enter the parameters for your IR video
stream.
The IR Stream Name contains the
connection string for the IP video. The
default value recognized by FSM as
ch0 is:
rtsp://192.168.250.116/ch0.
Enter the appropriate IP video
connection string for your installation.
Step 3 Click Video DLTV. The screen at the
right will be displayed.
Step 4 Enter the parameters for your Visible
video stream.
The DLTV Stream Name contains the
connection string for the IP video. The
default value recognized by FSM as
ch2 is:
rtsp://192.168.250.116/ch2.
Enter the appropriate IP video
connection string for your installation.
2.4.4 Analog Video Configuration—Video Matrix
Click Video Matrix The screen at the
right will be displayed.
The PT-Series camera provides two
analog video ports: Main and Auxiliary.
• You can select the source of each
port from this screen.
• Set the Device type (set Device ID)
for each source.
• Set Picture-In-Picture (PIP) for each
port.
427-0032-00-12, version 150 January 2012
2—Verify Camera Operation
2-7