Serial Remote Menu - FLIR PT-Series Installation Manual

2—Verify Camera Operation
2.4.2

Serial Remote Menu

The settings you make in this screen will become active when the software override DIP switch
is set to Off (the default) allowing software settings to control the camera. Refer to paragraph
1.14 "Setting Configuration Dip Switches" on page 1-9.
Step 1 Click Serial Remote. The screen at
the right will be displayed.
Step 2 Select the Protocol for your serial
control configuration
(Pelco-D Serial Remote in this
example).
Step 3 Select Device ID: 1 to see the Pelco-D
advanced settings. (If you selected
Bosch Serial Remote in 2 above, you
will select Device ID: 2 to see the
Bosch advanced settings.)
Step 4 Enter the parameters for your specific
location.
Step 5 Scroll down to see more advanced
settings.
Scanlist Serial Control
Step 1 Scroll down until you see the
Advanced Settings section shown in
the screen at the right.
Step 2 Enter the scanning parameters for
your specific location.
2-6
Select Device ID
January 2012
PT-Series Installation Manual
427-0032-00-12, version 150