Power; Analog Video; Gige Digital Video - FLIR A6700sc User Manual

4 – Installation

4.1.1 Power

Plug in the AC power supply to a standard 120V outlet. Connect the DC power cable between the
power supply and the power connector located on the rear panel of the A6700sc camera. Turn on
the imaging head by pressing the power button on the rear panel. The green power LED will
illuminate to indicate that the unit is ON.

4.1.2 Analog Video

The camera will automatically boot up into the last saved state. The boot process takes about 30
seconds. To see the Composite video on a monitor, connect the provided BNC cable from the VIDEO
port to your monitor. If you are powering up the camera for the first time, the camera should produce
a 640x480 image with Non-Unifority Correction (NUC), bad pixel replacement enabled.

4.1.3 GigE Digital Video

If you have a PC data system running ResearchIR (or your own custom application based on the BHP
SDK) you can view the 14-bit digital video over Gigabit Ethernet.
The A6700sc has a Gigabit Ethernet interface that is GigE Vision (GEV) and GenICam compliant Use
a regular CAT5e or CAT6 Ethernet patch cable. If a crossover cable is used, the camera interface will
automatically detect and configure itself to work with this kind of cable.
A6700sc/A6750sc User's Manual 12