Smart Box (Configuration By Telemetry) - GRAUPNER X-4S HoTT SJ Operating Instructions Manual

Electric & Engine model configuration
Red wire sensor cable
ESC
T/V Connector
CH2 Connector
CH1 Connector
<Electric model Configuration>
T/V Connector
B/T Connector
CH2 Connector
CH1 Connector
<Engine model Configuration>
Connect a battery to red cable(+)
Battery connection
Motor connection
Power switch
Temperature sensor
Steering Servo
Connect temperature sensor to Engine head
Receiver battery
Throttle Servo
Steering Servo

◎ Smart Box (Configuration by Telemetry)

The use of optional smart box supports easy configuration.
When operating in SETTING & DATA VIEW mode in telemetry box,
the screen appears as follows.
RECEIVER 0.01 >
>AL RX-V(5.1V) : 3.7V
AL RX-T(+33`c): 65`C
PERIOD : 10ms
AL EX-V( 7.4V): AUTO
AL EX-T( 27`C):100`C
Smart Box (#33700)
1. ALARM VOLT
It is used for low battery warning program. (Adjustable from 3.5V to
8.0V)
The default value is 3.7V.
2. ALARM TEMP
It is used for receiver's warning program (Adjustable from 30℃ to
80℃)
The default value is 65℃
3. PERIOD
It is used to set the speed of receiver's output signal. (Selectable
10msec or 20msec)
14