Receiver Installation - Daikin BRC7E530W8 Installation Manual

Setting the address of wireless remote controller
(See figure 3)
A Mode
B Address (is factory set to "
C Multiple setting
Setting from the remote controller
1 Hold down the button and the
at least 4 seconds to get the Field Set mode.
(Indicated in the display area in the figure.)
2 Press the button and select a multiple setting
( a / b ). Each time the button is pressed the display
switches between " a " and "
3 Press the button and
Address can be set from 1 to 6, but set it to 1~3 and
to same address as the receiver. (The receiver does
not work with address 4~6.)
4 Press the button to enter the setting.
5 Hold down the
to quit the Field Set mode and return to normal
display.
a b
Multiple setting /
When the indoor unit is being operated by outside control
(central remote controller, etc.), it sometimes does not
respond to ON/OFF and temperature setting commands
from this remote controller. Check what setting the
customer wants and make the multiple setting as shown
below.
Remote controller
Remote
Multiple controller
setting display
All items
a : Standard
displayed.
Operations
b : Multi
remain
System
displayed
shortly after
execution.
BRC7E530+531W8
Wireless remote controller kit
1 ")
button for
b ".
button to set the address.
button for at least 1 second
Movement when the
operation is controlled by
the other air conditioners
and equipment
When operation
changeover, temperature
setting or the like is
carried out from the
remote controller, the
indoor unit rejects the
instruction.
(Signal receiving sound
"peeh" or "pick-pick-pick")
As a result, a discrepancy
between the operation
state of the indoor unit and
the indication of the remote
controller display occurs.
Since the indication of the
remote controller is turned
off, no discrepancy such
as mentioned above
occurs.
4PW23710-1A
Stick the unit number label
Stick the unit number label on the air outlet of the
decoration panel and on the back of the wireless remote
controller.
NOTE Set the Unit No. of the receiver and the
wireless remote controller to be equal. If the
settings differ, the signal from the remote
controller cannot be transmitted.

Receiver installation

1 Refer to figure 5. Pass the harness from the receiver
through the wiring hole of the decoration panel. Then,
attach the receiver to the decoration panel.
2 Refer to figure 6. Hook the harness from the receiver
of the decoration panel. Be sure to push the harness
to the groove.
1 Panel temporary suspension
3 Attach the decoration panel to the indoor unit.
(Refer to the installation manual attached to the
decoration panel.)
4 Refer to figure 8. Connect the harness from the
receiver to the connector X1A on the transmitter
board.
After connecting, use the clamp to fix the two
harnesses to the transmitter board box.
1 Clamp
5 Refer to figure 7. Use two tapping screws to attach
the transmitter board to the indoor unit, as shown in
the figure.
Installation manual
3