Advertisement
3.
REMOTE CONTROLLER INSTALLATION
<Installing wireless remote controller>
• Do not throw the remote controller or impose large shocks.
Also, do not store where it may be exposed to moisture or
direct sunlight.
• When operating, point the transmitting part of the remote
controller in the direction of the receiver.
• The direct transmitting distance of the remote controller is
approximately 23 ft..
• The signal cannot be transmitted if something such as cur-
tains blocks the receiver and the remote controller.
• Installing to a wall or a pillar
1. Fix the remote controller holder (5) with
the screws (8).
2. Slide the remote controller (4) into the
remote controller holder (5) from the top.
• How to put the dry cell batteries
1. Remove the back cover of the remote control-
ler (4) to the direction pointed by the arrow
mark.
2. Put the dry cell batteries.
Use two LR03<AM4> dry cell batteries (6).
Put the dry cell batteries correctly to fit their
(+) and (–).
3. Close the back cover as before.
4.
RECEIVER INSTALLATION
4-1. Preparations before installation
Remove the suction grille, the decoration panel and the
protection net according to the installation manual
attached to the indoor unit.
4-2. Determination of address and MAIN/SUB remote con-
troller
If setting multiple wireless remote controllers to operate in
1 room, perform address setting for the receiver and the
wireless remote controller. If setting multiple wired remote
controllers in 1 room, change the MAIN/SUB switch of the
receiver.
4-3. Setting procedure
• Setting the receiver
Set the wireless address switch (SS2) on the transmis-
sion PC-board assembly (2) according to the table below.
Unit No.
No.1
Wireless
address
switch
(SS2)
3
No.2
No.3
The side painted black indicates
the switch knob position.
CAUTION
Change the setting so that the internal electronic equipments
are not damaged with a pen etc.
When using both a wired and a wireless remote controller
for 1 indoor unit, the wired controller should be set to MAIN.
Therefore, set the MAIN/SUB switch (SS1) of the receiver
to SUB.
MAIN
MAIN/
SUB
S
switch
M
(SS1)
4-4. Receiver installation
WARNING
Be sure to turn off the power before installtion.
(2)
(3)
B
D
Side panel
assy (right)
Receiver
assembly (1)
Penetrating hole
• Remove the name plate mount of the indoor unit.
(1) Inset the tip of the flat blade (–) screwdriver into the
place shown by the convex mark
the name plate.
(2) Tilt the screwdriver in the direction shown by the arrow.
(both A and B)
Transmission PC-board
assembly (2)
SUB
S
M
(1)
Name plate
mount
Name
plate
C
Projection
Notch
Bottom plate
(both A and B) of
Advertisement
