Field Setting - Daikin BRC7E530W8 Installation Manual

6 Refer to figure 9. Connect the harness from the
transmitter board to the connector X24 on the indoor
unit PC board.
A Be sure to pass only the harness
connecting to the indoor unit PC board
under the tab.
B Be sure to wire the harness as shown to
avoid the harness to be caught by the
control box and the control box lid.
C Position of the connector in the case of the
VRV system.
F
IELD SETTING
If optional accessories are mounted on the indoor unit,
the indoor unit setting may have to be changed. Refer to
the instruction manual (optional hand book) for each
optional accessory.
Example
If the time to clean air filter is set to "Filter Contamination-Heavy", set MODE NO. to "
and SECOND CODE NO. to "
FIRST
MODE CODE
NO. NO.
Filter Contamination-Heavy/Light
(Setting for spacing time of display time
to clean air filter) (Setting for when filter
0
contamination is heavy, and spacing
time of display time to clean air filter is to
10
be halved)
Spacing time of display time to clean air filter count
(Setting for when the filter sign is not to be
3
displayed)
ON/OFF input from outside (Set to enable starting/
1
12
stopping from remote.)
(VRV
Thermostat differential changeover (Set when using
system)
2
remote controller thermostat sensor.)
Selection of Air Flow Direction (Setting for when a
sealing member of air discharge outlet kit has been
1
13
installed)
Air Flow Direction Range Setting
4
1 NOTEThe SECOND CODE NO. is factory set to "01". However, for the following cases it is set to "02".
• Air Flow Direction Range Setting
Do not use any settings not listed in the table.
For group control with a wireless remote controller, initial settings for all the indoor units of the group are equal. (For
group control, refer to the installation manual attached to the indoor unit for group control.)
Installation manual
4
02
".
Description of setting
4PW23710-1A
(See figure 4)
A MODE NO.
B FIELD SET MODE
C FIRST CODE NO.
D SECOND CODE NO.
Procedure
1 When in normal mode, press the
a minimum of four seconds, and the FIELD SET
MODE is entered.
2 Select the desired MODE NO. with the
3 Push the button and select the FIRST CODE NO.
4 Push the button and select the SECOND CODE
NO.
5 Push the
are SET.
6 Push the button to return to the NORMAL
MODE.
SECOND CODE NO.
0 0 0 0 1 1 1 1
Long-life ±2500
Light
type hours
Display
Forced OFF
input
1°C
F
Upper
button for
button and the present settings
10 ", FIRST CODE NO. to "
1
0 0 0 0 2 2 2 2
±1250
Heavy
hours
Do not display
ON/OFF
0.5°C
T
Normal
BRC7E530+531W8
Wireless remote controller kit
button.
0 ",
0 0 0 0 3 3 3 3
—
—
—
—
W
Lower