Advertisement
• How to insert the batteries
1. Open the back cover of the remote controller
by sliding it in the direction of the arrow.
2. Insert the attached dry cell batteries. Properly
insert, set the batteries by matching the (+)
and (–) polarity marks as indicated. Then
close the cover as before.
4. RECEIVER INSTALLATION
(1) Preparations before installation
1. Detach the brand name plate part of
the decoration corner panel piece,
before attaching the decoration
panel. This part is not needed
hereafter.
2. Next, remove the suction grille
and the air filter according to the
instructions in the installation manual
attached to the decoration panel.
3. Remove the control box cover
according to the instructions in the
installation manual attached to the
indoor unit.
(Be sure to turn off power, before
removing the control box cover.)
(2) Determination of address and MAIN/
SUB remote controller.
If setting multiple wireless remote
controllers to operate in one room,
perform address setting for the receiver
and the wireless remote controller.
If setting multiple wired remote
controllers in one room, change the
MAIN/SUB switch of the receiver.
3
Push three hooks to
detach them from the
holes of the rear side.
Decoration
panel
Brand name plate part
3P155845-5H English
Hide quick links:
Advertisement
