Remote Controller Installation; Installing Wireless Remote Controller; Receiver Installation; Preparations Before Installation - Daikin BRC7E530W8 Installation Manual

R
EMOTE CONTROLLER INSTALLATION

Installing wireless remote controller

Do not throw the remote controller or impose large
shocks. Also, do not store where it may be exposed
to moisture or direct sunlight.
When operating, point the transmitting part of the
remote controller in the direction of the receiver.
The direct transmitting distance of the remote
controller is approximately 7 meters.
The signal cannot be transmitted if something such
as curtains blocks the receiver and the remote
controller.
Installing to a wall or a pillar
1 Fix the remote controller holder
with the screws.
2 Slide the remote controller into the
remote controller holder from the
top.
How to insert the batteries
1 Open the back cover of
the remote controller by
sliding it in the direction
of the arrow.
2 Insert the attached dry
cell batteries. Properly
insert, set the batteries
by matching the (+) and
(–) polarity marks as
indicated. Then close the
cover as before.
R
ECEIVER INSTALLATION

Preparations before installation

(See figure 2)
1 Detach the brand name plate part of the of the
decoration corner panel piece, before attaching the
decoration panel . This part is not needed hereafter.
2 Next, remove the suction grille and the air filter
according to the instructions in the installation
manual attached to the decoration panel.
3 Remove the control box lid according to the
instructions in the installation manual attached to the
indoor unit. (Be sure to turn off power, before
removing the control box lid.)
1 Push three hooks to detach them from the
holes of the rear side.
2 Brand name plate part
3 Decoration panel
Installation manual
2
Determination of address and MAIN/SUB
remote controller
If setting multiple wireless remote controllers to
operate in one room, perform address setting for the
receiver and the wireless remote controller.
If setting multiple wired remote controllers in one
room, change the MAIN/SUB switch of the receiver.

Setting procedure

(2)
Setting the receiver
(1)
Set the wireless address switch (SS2) on the transmitter
board according to the table below.
Wireless address switch
(SS2)
When using both a wired and a wireless remote
controller for 1 indoor unit, the wired controller should be
set to MAIN. Therefore, set the MAIN/SUB switch (SS1)
of the transmitter board to SUB.
MAIN/SUB switch (SS1)
4PW23710-1A
Unit No.
1 2 3
MAIN SUB
S S
M M
BRC7E530+531W8
Wireless remote controller kit