Advertisement
• The direct transmitting distance of the remote controller is
approximately 23 ft..
• The signal cannot be transmitted if something such as cur-
tains blocks the receiver and the remote controller.
• Installing to a wall or a pillar
1. Fix the remote controller holder (3) with
the screws (6).
2. Slide the remote controller (2) into the
remote controller holder (3) from the top.
• How to put the dry batteries
1. Remove the back cover of the remote con-
troller (2) to the direction pointed by the
arrow mark.
2. Put the dry cell batteries.
Use two LR03<AM4> dry cell batteries (4).
Put the dry cell batteries (4) correctly to fit
their (+) and (–).
3. Close the back cover as before.
4.
RECEIVER INSTALLATION
4-1. Preparations before installation
Remove the control box lid and the front grill. See the
installation manual that came with the indoor unit for
details on removal.
4-2. Determination of address and MAIN/SUB remote con-
troller
If setting multiple wireless remote controllers to operate in
1 room, perform address setting for the receiver and the
wireless remote controller. If setting multiple wired remote
controllers in 1 room, change the MAIN/SUB switch of the
receiver.
4-3. Setting procedure
• Setting the receiver
Set the wireless address switch (SS2) on the transmis-
sion PC-board (2) according to the table below.
Unit No.
No.1
Wireless
address
switch
(SS2)
3
No.2
No.3
CAUTION
Change the setting so that the internal electronic equipments
are not damaged with a pen etc.
When using both a wired and a wireless remote controller
for 1 indoor unit, the wired controller should be set to MAIN.
Therefore, set the MAIN/SUB switch (SS1) of the receiver
to SUB.
MAIN
MAIN/
SUB
S
switch
M
(SS1)
After completing setting, seal off the opening of the
address switch and the MAIN/SUB switch with the
attached sealing pad.
4-4. Receiver installation
CAUTION
Be sure to turn off the power before operation.
(1) Detach the swing motor and the diagonally opposite
decoration corner panel. This corner panel piece is not
needed here after. (Refer to (1) in drawing)
<For instructions on attaching / detaching decoration
panels, see the installation instructions provided with
the original panel.>
The receiver (1) cannot be installed anywhere but
in this corner.
SUB
S
M
Advertisement
