Sharp DX-B350P User Manual page 121

Error Message Line 1
JOBLIB Error 03
JOBLIB Error 04
JOBLIB Error 05
Load Paper Tray x
Loading
Maintenance Reqd
Mem Size Changed
Net1: Comm Error
Net1: Error 1
Net1: Error 2
Net1: Error 3
Net1: Error 4
Not Ready
NVRAM Failure xx
Out Of Memory
Panel Locked
Power Save Mode
User's Guide
Downloaded From ManualsPrinter.com Manuals
Error Message Line 2 Possible Cause
Press Start JobLibrary private mode
datastream missing PIN.
Press Start JobLibrary datastream
attempted to overwrite a
Private job, but PIN did
not match.
Press Start JobLibrary has insufficient
storage
Media size and type The requested size and
type of paper was not
sensed in the tray
First stage of printer boot
cycle
Printer has reached the
maintenance interval of
200,000 pages.
xxxM (Was xxxM) Printer recognizes that
optional memory was
installed or removed
Press Start Communications error
with optional interface
Press Start Serial interface option:
overrun error
Press Start Serial interface option:
parity error
Press Start Serial interface option:
framing error
Press Start Serial interface option:
flow control error
Printer is offline
Controller failure
The job is too complex for
the installed memory
The printer panel has been
locked to prevent changes
Printer is in power save
mode
Error and Warning Messages
Troubleshooting
Action
Ensure the PIN is entered
Ensure the PIN matches or change the
Job Name
Delete unneeded files from the printer
disk
Load paper of the size and type noted.
Use the Status key to check that paper
size and type is correct for the tray.
None
Normal Printer Operation
Press Start to acknowledge the
condition. Please contact your dealer or
authorized service representative for
assistance in maintenance.
Press Start to acknowledge
Remove the optional interface and
restart the printer. Call service.
Verify that the handshaking protocol
settings match between the printer and
the host.
Verify that the parity settings match
between the printer and the host.
Verify that the serial settings match
between the printer and the host.
Verify that the handshaking protocol
settings match between the printer and
the host.
Press Start
Restart printer. If the problem reoccurs,
call service
Add optional memory
Contact the administrator
None
Normal Printer Operation
Printer automatically returns to normal
mode when data is received.
9-11