Sharp DX-B350P User Manual page 37

User's Guide
Downloaded From ManualsPrinter.com Manuals
Menu Item Value
Network Address <hex display
of MAC
address>
IP Address data entry
Subnet Mask data entry
Default Gateway data entry
LPD Banner On/Off
DHCP On/Off
IPv6 On/Off
Delay Out Close On/Off
mDNS On/Off
Local Link read-only
Multi-Session On/Off
EtherTalk On/Off
Netware Setup
Netware On/Off
Netware Frame Auto-Sense,
802.3,
Ethernet II,
802.2 SNAP,
802.2
Netware Mode NPRINTER
PSERVER
Default Description
NA Displays MAC address of network interface.
000.000.000.000 IP Address. If DHCP is enabled, this is
read-only. Otherwise, this can be changed by
the address can be set manually here
000.000.000.000
000.000.000.000
Off If ON, prints a special "banner page" before
each LPR print job.
On
Off
Off When ON, the printer will wait until the job
is completely printed and delivered to the
output tray before terminating the
connection, allowing all reverse-channel
data to be sent back to the host. This will
cause a reduction in printer throughput.
When OFF, reverse-channel data generated
after the job interpretation is discarded. No
reduction in printer throughput occurs.
On Enabled multicast-DNS protocol. mDNS is
the underlying protocol for "Bonjour".
000.000.000.000 Auto-negotiated "local link" internet address
(used primarily by Bonjour protocol)
Off When On, allows the printer to have
multiple network print sessions open at a
time. When Off, only 1 session can be
opened at a time. Some server environments
may benefit from a setting of Off.
On
This submenu allows you to set up the
Netware interface.
Off
Auto-Sense
PSERVER
Operator Panel Menus
Operator Panel
3-11