Reverse The Door Opening - BOMANN KS 163 User Manual

REVERSE THE DOOR OPENING

If required, the door opening can be moved from the right (supplied condition) to the left side.
WARNING
When replacing the door stop, the device must be disconnected from the power supply.
Always unplug the device first.
1. Use a screw-driver to remove the screw covers (11) at the device top cover. Unscrew the below
screws (10) and remove the device cover (9).
2. Put the blind cap (8) of the device top cover (9) at the opposite side.
3. Dismount the upper door hinge (5) by unscrewing the screws (6).
Open the door a little, take the door carefully from the lower door hinge (2).
4. Put the blind cap (7) of the device door at the opposite side and place the door on a padded sur-
face to prevent it from scratches.
5. Tilt the device slightly backwards and block it in this position.
Unscrew both feet (3) and (4) and remove the lower door hinge (2) by unscrewing the screws (1).
6. Move the hinge (2) to the other side of the device accordingly and fix it with the screws (1).
Screw both feet (3) and (4) on again.
7. Replace the device in the upright position again. Insert the device door on the hinge pin of the low-
er door hinge (2) and fix the door to the property position.
8. Attach the upper door hinge (5) by using the screws (6) to the opposite side accordingly.
9. Put the in point 1 removed device top cover on again, tight the screws (10) and clip the screw cov-
ers (11) on.
Check if the door is arranged vertical as well as horizontal, so that a smooth opening and closing of
the door is ensured.
Reverse the freezer flap opening
Open the freezer flap a little. Press the spring of the lower bracket up
slightly with a small screw-driver and remove the bracket incl. freezer flap.
Place the blind cap (M) at the opposite side. Turn the freezer flap about
180° and press the lower flap bracket into the appropriated fixture of the
freezer flap.
Lift the freezer flap a little and fix it in the upper door bracket, at the same
time you press the lower door bracket in the square hole. Small adjust-
ments to the top and bottom will easily the mounting of the flap.
7
07/2010