Risk Of Injury; Coolant; Intended Use; Unpacking - BOMANN KS 163 User Manual

Risk of injury!

• So that you can disconnect the appliance quickly in event of an emergency, do not use extension
cables.
• This device may not be operated by children or persons with physical, sensory or mental abilities or
lack of experience and knowledge, unless they are supervised or guided.
• Children should be supervised to ensure that they do not play with the device.
• Transport the unit never with content.
WARNING
Packaging materials (e.g. plastic bags, polystyrene) are dangerous for children.
Risk of suffocation! Keep packaging materials out of reach of children.
WARNING
Containers with flammable gases or liquids can leak due to cold ambient temperatures.
Risk of explosion! Do not store combustible materials such as aerosol cans or refill car-
tridges for lighters in your device.

Coolant

CAUTION
The coolant circuit of this device contains the refrigerant isobutane (R600a), a natural
gas that is flammable and of high environmental compatibility. Make sure no parts of
the Coolant circuit gets damaged during transport and installation of the device.
If the coolant circuit is damaged:
• it is imperative to avoid any open flames or ignition source.
• thoroughly air the room in which the device is installed.

Intended use

• This device is intended for private use. It is suitable for cooling/freezing food.
• The manufacturer is not reliable for any damage resulting from improper or other then intended
use.
• For safety reasons, alterations or modifications of the device are prohibited.
• Please keep in mind that the manufacturer is not reliable for any damage resulting from commercial
or any other use then cooling/freezing food.

Unpacking

The packaging must be undamaged. Check the device for any possible transport damage. Do not
install a damaged device. In case of damage, please contact your distributor.
Packaging material
The packaging for transportation of the device and individual parts is produced of recyclable materials.
• corrugated cardboard / paperboard (mainly of waste paper)
• form part of PS (foamed, CFC-free polystyrene)
• Films and bags of PE (polyethylene)
• Strapping strips of PP (polypropylene)
WICHTIG
Make sure you dispose of packaging materials environmentally friendly (see page 3).
Removing the transport protection
The device and parts of the interior are protected for transport. Remove all adhesive tapes from the
right and left side of the door. You may remove adhesive residue with a cleaning solvent. Also remove
any adhesive tapes and packaging materials from the inside of the device.
4
07/2010