Reverse The Door Opening; Startup / Operation; Prior To First Use; Operation - BOMANN KS 263 User Manual

R T D
EVERSE HE OOR
If required, the door opening can be moved from the right (supplied condition) to the left side.
WARNING
When replacing the door stop, the device must be disconnected
from the power supply. Always unplug the device first.
1. Use a small flat screwdriver to lift up the two screw covers
(1) on the top cover (3).
2. Use a cross screwdriver to remove the two screws (2) on the
top cover and the other two screws (11) on the backside of
top cover.
3. Lift up the top cover (3) and pull out the door hinge pin (4)
from the door, and put them on a safety place for later use.
Lift up the door (6) and put it on a safety place for later use.
4. Remove the left adjustable foot (7) and the right adjustable
foot (8) and screws (9) and keep them for later use.
5. Move the lower hinge (10) from the right side to the left side,
then fix it with the screws (9). Then install the right adjustable
foot (8) on the left and the left adjustable foot (7) on the right.
6. According to the reversible way of above procedure to install
the door (6), then put the door hinge pin (4) into the left hole of the door, then put the top cover (3)
on it, please make sure the door hinge pin (4) to be placed into the hole of the top cover (3), then
use the cross screw drive to fix the screws (2) and the screws (11), finally put the screw covers (1)
on it.
Check if the door is arranged vertical as well as horizontal, so that a smooth opening and closing of
door is ensured.
S / O
TARTUP PERATION

Prior to First Use

ATTENTION: After transport, the device should be left standing for 4 hours in order for the oil to
be collected in the compressor. Nonobservance could cause damage to the compressor and hence
result in failure of the device. This would void your warranty claim.
- Clean the interior of the device including all accessory parts located inside.
Connect the Device to the Mains Supply
IMPORTANT
- The device must be earthed properly. For this purpose the plug of the mains cable has been fitted
with the intended lead.
- Contact an electrician if the plug does not fit in the wall socket.
- In case you disconnect the device or in case of power failure: Wait for 5 minutes before restarting
the device.

Operation

Turn on the device by connecting the plug to a wall socket and turning the temperature control, which
is located at the right side of the fridge interior. Please also refer to chapter 'Settings'.
Settings
Setting 0 – OFF indicates the device is turned off.
Turn the temperature control clockwise, starting from this setting; the device will turn on automatically.
The Settings 1 MIN – 7 MAX regulate the inside temperature. When opening the door, the interior
lamp will turn on.
Setting 0 (or OFF)
Setting 1 (or MIN)
Setting 7 (or MAX)
O
PENING
= Off
= lowest setting (warmest inside temperature)
= highest setting (coldest inside temperature)
6
11/2012