Setting Up Your Captel 2400I - Ultratec CapTel 2400i User Manual

Setting up Your CapTel 2400i

For complete instructions, please see the Setup Guide.
Requirements
1. High-speed Internet access using a DSL or Digital Cable modem.
Your CapTel 2400i can connect to your Internet service either with an
Ethernet cable or through a wireless (WiFi) network. Depending on your
Internet setup, a router may also be required to allow you to connect
more than one device to your Internet service.
2. Telephone Service. Can be analog line, DSL with filter, VOIP, FIOS, or
Digital Cable phone service. CapTel does NOT work with digital Private
Branch Exchange (PBX) systems found in some office environments,
residential facilities, and hotels – unless an analog port is available.
3. Standard electrical power (AC adapter plugs into standard wall outlet).
Step 1: Select a Location
Set up the CapTel 2400i in a place where:
• A high-speed Internet (Ethernet) jack or your wireless router is
located nearby.
• A telephone jack is located nearby (can be analog line, DSL with
filter, VOIP, FIOS, or Digital Cable phone service).
• There is an electrical outlet nearby.
• The surface it will be set on, or mounted to, is stable and secure.
• The area is protected from excessive heat or humidity.
The outlets for power, the phone line, and the Ethernet connection should all
be located nearby, as each cord needs to plug into your CapTel 2400i. If your
Internet access is located in a different room than where you plan to use the
CapTel 2400i, a WiFi setup is recommended. Please see the Setup Guide or
contact CapTel Customer Service for help setting everything up.
12
G E T T I N G S TA R T E D Customer Service: 888-269-7477