Refilling The Sealing Solution; Handling Material Stoppages; Clearing A Stoppage - Secap SI5400 Operator's Manual

Refilling
the Sealing
Solution
Handling
Material
Stoppages
Clearing a
Stoppage
SV61611 Rev. B
A warning message appears on the Display screen indicating that it is time
to replenish sealing solution in the Sealer bottle :
To refill the bottle:
1. Open the Sealer bottle cover and remove the bottle from its holder on
the system and place it on a flat surface.
2. Unscrew the pressure-sensitive top and remove it from the bottle.
3. Pour sealing solution into the bottle until it reaches the fill line.
NOTE: Water is an acceptable liquid to use in the Sealer, but is not recom-
mended. The use of water can result in bacterial growth that can inhibit the
performance of the Sealer.
5. Screw the pressure-sensitive top securely back onto the bottle.
6. Wipe off any excess fluid that may have spilled.
7. Put the bottle back into the holder and close the Sealer cover.
NOTE: First time use of the sealing system, as well as situations in which the
wick has become dry, will require a brief waiting period to allow the wick to get
moist.
If a stoppage occurs, the system immediately stops the run and displays an
error message. Follow the instructions on the Display screen to get your
system running again.
The procedure(s) involved with removing material that has caused the stop-
page, resuming the run, and handling the outsorts are explained next.
The procedure for clearing a stoppage varies and depends on the area in
which the stoppage occurs. In general, the steps to clear a stoppage consist
of the following:
1. Use the error message information on the Display screen to locate the
problem area.
2. If needed, open any covers that allow access to the stoppage. Clear only
the area indicated. If prompted to clear deck, press CLEAR DECK.
Refer to Chapter 2 if you need help on cover removal and/or use of the
Paper Release Knobs for accessing and removing stoppage.
3. Follow the instructions on the Display screen to clear the stoppage.
4. Once the stoppage is cleared, close any open cover(s). The error mes-
sage will clear and the Home screen will display.
Troubleshooting • 5
5-5