Replacing The Envelope Edge Marker Roller - Secap SI5400 Operator's Manual

7 • Add-On Modules
Replacing the
Envelope Edge
Marker Roller
7-8
The Flats Sealer also contains an envelope edge marker. The envelope
edge marker will apply a mark at least 0.5" (12.5 mm) in length along the
edge of the envelope facing the operator.
You can use edge mark can be used to indicate tray breaks, ZIP breaks,
every 50th envelope, high value checks, etc.
NOTE: The envelope edge mark is applied only to envelopes passing through the
letter exit path.
Envelope Edge Marker Roller
Figure 7.9: Flats Sealer Cover Open
Follow the steps below to remove and replace the Envelope Edge Marker
Roller.
NOTE: Avoid touching the ink roller, as it is covered in ink.
1. Open the Flats Sealer cover.
2. Grasp the tab at the top of the old ink roller and lift to remove.
3. Grasp the tab at the top of the new ink roller and slide it onto the spin-
dle.
4. Release the tab once the ink roller is seated firmly in place.
5. Close the Flats Sealer cover.
Letter Envelope Exit
Flat Envelope Exit
SV61611 Rev. B