Secap SI5400 Operator's Manual page 79

Insert Options
(continued)
SV61611 Rev. B
Menu Item Associated Options and Actions
Additional Settings Double Detect allows the system sense when multiple inserts are
fed unintentionally.
NOTE: This menu option is not available when the job requires a
Custom Feeder.
•
•
•
•
Feeder Type allows you to change the Feeder setting when
material is problematic, or to indicate that the job requires a Custom
Feeder.
NOTE: This menu option is not available when the job requires an
Attached Printer.
•
•
•
Feeder Linking allows multiple Feeders to feed the same material.
NOTE: This menu option is not available when the job requires a
Custom Feeder.
•
•
Scan Items allows you to indicate whether or not an item should be
scanned.
Toggle:
•
•
Double Detect Feature allows you to toggle:
- Off means this feature will not function for this item, or
- On means this feature is active.
Locaton allows you to toggle:
- Default, or
- Custom.
Custom Locaton for Top Edge allows you to enter a specific
measurement (the distance from the edge feeding first into the
feeder) where the system should attempt to detect a double.
NOTE: Set this option when Location is set to "Custom". The
double detect region cannot be within 25 mm of the lead or trail
edges of the insert.
- Use the UP/DOWN arrow keys to adjust the measurement
(in millimeters).
- Select "Accept" when you are done.
Acton On Double allows you to select where the items should
be fed to if a double is detected.
Normal is used for most items.
Manual Feed is used when items will be fed into the system
by hand. Refer to Manual Feeder in Chapter 2 for more
information.
Custom Feeder is used when items will be fed into the system
by the Custom Feeder.
None means there is no linking of Feeder Trays.
Two Feeders indicates that two Feeder Trays are linked and
feeding the same material.
Yes means this feature is active, or
No means this feature will not function for the item.
Basic Operation • 3
3-37