Additional Information; Bcr And Omr Mark Levels - Secap SI5400 Operator's Manual

Additional
Information
BCR and OMR
Mark Levels
SV61611 Rev. B
• Paper weight range for OMR is 18 lb. (75 gsm) to 32 lb. (120 gsm).
• Feeder linking will only work correctly if the operator has started with the
correct sheet (i.e. linking can only be done reliably on a collation break).
The feed order and print order will determine if feeder linking is possible.
Some sort of collation integrity (WAS or MC) to ensure right pieces are in
the right collations.
• Selective feed of additional sheets is always available up to the maxi-
mum limits of either folder (8 sheets of 80 gsm paper or equivalent) or
25 sheets into a flat envelope.
• For PC Controlling setup and operation, refer to the help system pro-
vided with your SureTrac
This section gives brief descriptions of the available BCR and/or OMR
marks. There are three levels of scanning. Each level contains specific
marks.
Basic Level
Beginning of Collation (BOC)
End of Collation (EOC)
Benchmark (BM)
Checksum (CS)
Parity (PAR)
Safety (SAF)
Ignore (IGN)
Timing (TM)
Divert Finished (DVF)
Stop (ST)
NOTE: You may or may not have all of these marks available to you, depend-
ing upon the level(s) of OMR scanning you have purchased. However, if barcode
scanning is enabled, all of these options will be available.
The "About My Machine" screen shows the level of scanning that has been en-
abled on your system. Follow the steps below to navigate to the screen:
1. From the Home screen, select "Menu", then "Tools".
2. Select "About My Machine".
One of the following marks must be present and must be marked as "Is con-
trolling" in the system: EOC, BOC, PC, or MC.
• EOC is most frequently marked as "Is controlling".
• Additional restrictions apply to BOC and MC when marked as "Is Con-
trolling".
Process Verification software.
™
Enhanced Integrity
Level
Wrap Around Sequence
(WAS)
Match Code (MC)
Page Count (PC)
Page Number (PN)
Scanning • 8
Selective Operations
Level
Select Feed (SF)
Env Select (ES)
Select Next (SN)
Seal (SL)
Divert Sheets (DVS)
8-31