Adjusting The Scan Heads For Picket Orientation Marks - Secap SI5400 Operator's Manual

8 • Scanning
Adjusting the
Scan Heads
for Picket
Orientation
Marks
8-22
To adjust the scan heads:
1. Fold one of the sheets to be scanned
in half vertically (side with mark facing
up.)
2. Draw two arrows, one at the top of the
mark, and one at the bottom of the
mark, pointing towards the top of the
sheet.
3. Fold the sheet horizontally, so the bar-
code appears on either side of the fold
line.
4. Open the Main Transport Deck Cover.
Use the ruler to measure the distance
from the center of the sheet (lined up
at 0 on the ruler) to the center of the
marks.
5. Refer to the loading instructions to
determine:
• The Scan Head location to be
used for this sheet (Left or Right)
• If the sheet will be loaded Top or
Bottom first.
6. Open the HCSF Tower cover.
TIPS:
• Remove the left Feeder Trays from the Feeder Tower to allow the
HCSF Tower cover to open freely.
• If you have two HCSFs on your system, the first HCSF Tower will pre-
vent the second tower (farthest) from opening fully. For best results,
be sure you have proper lighting when adjusting the Scan Head in the
second tower.
Vertical
fold
Horizontal
fold
SV61611 Rev. B