Quick Start Guide - Yeti Cycles SB5C Owner's Manual

SHOCK SETUP
04. COMPRESSION DAMPING
The compression dampening has three levels of
adjustment and is controlled by the blue lever on
the shock. The "climb" mode engages the firmest
low-speed compression setting for maximum
pedaling efficiency. The "trail" mode engages
a moderate low-speed compression setting for
a blend of pedaling efficiency and bike control,
on various riding terrain. Finally, the "descend"
mode sets the low-speed compression setting to
fully open, for maximum bike control and shock
absorbency. This is the setting you will likely use
the most on the SB5c.
QUICK START GUIDE - CTD ADJUST
ADJUSTMENT SETTING
AIR SPRING SETTING (PSI) RIDER WEIGHT LESS 10 PSI
MEASURED SAG (MM) 15-16MM
REBOUND *5 CLICKS
COMPRESSION DAMPING BASED ON TERRAIN
TRAIL ADJUST OPEN (DESCEND)
*All clicks are counted clockwise, rotating from the all the
way out or counter - clockwise dial position.
16.
05. TRAIL ADJUST
The trail adjust dial controls the "trail" mode low
speed compression adjustment. It has three
levels of adjustment and is controlled by the
black dial on the shock body. Turning the dial
clockwise increases low speed compression
damping, making the shock feel stiffer under low
speed compressions. Turning the dial counter-
clockwise will decrease low speed compression
damping, making the shock feel softer under low
speed compressions. Please note this adjustment
only affects the shock performance while riding in
"trail" mode.
17.