Advertisement
FRAME ASSEMBLY
YETI TIPS
Make sure your tools are in good condition.
A worn allen key can round the hex on a bolt
not allowing for proper torque.
Torque settings are listed throughout the
instructions. It is also import to prep all bolt
threads. The instructions denote whether to
use a Loctite compound or grease.
Warning: Service on Yeti bicycles requires special knowledge
and tools. Yeti Cycles recommends that all service and
repairs be performed by an authorized Yeti Dealer
20.
TOOLS NEEDED
• Dead blow hammer
• 2.5mm allen key
• Two - 5mm allen keys
• Two - 6mm allen keys
• 10mm allen key
• Guide pin tool
• Lock ring pliers
• Grease
• Blue (248) Loctite
• Pink (222) Loctite
01.
All the parts you need to assemble the SB5c.
03.
Slip washers onto and apply blue (248) Loctite to
the 4 bolts that secure the Switch Infinity Link to
the frame. Insert them into their place and hang
the black Infinity link fitting washers from them.
Place them with the flat side toward the opening.
02.
Secure your front triangle in a work stand using a
30.9 seat post. Make sure you have all your tools
easily accessible and ready to use.
04.
Insert the Infinity Link from the non-drive side.
The Infinity logo should be up and the Fox logos
facing the non-drive side. Rock the link into
place capturing the black fitting washers. Make
sure that they have not slipped or rotated. The
flat end of the fitting washers must be facing the
opening in the frame.
21.
Advertisement
