Advertisement
ASSEMBLY
13.
Using the 10mm Allen wrench, tighten the upper
link axle. Keeping the rag in place behind the
upper link to prevent paint damage.
Torque to 8nm
15.
Install the shock using two Fox guide pins and
remove the rag from behind the upper link.
24.
14.
Using a 5mm Allen wrench, install the collet bolts
into the non-drive side of the main pivot axle and
the upper link axle.
Torque to 10nm
16.
Using the guide pins insert the female shock
mounting sleeves from the drive side. Prep the
male bolts with blue (248) Loctite. Using two
5mm Allen wrenches tighten the front and rear
shock mounts.
Torque both bolts to 6.5nm
17.
Your bike comes with two cover options for the
internal seat post routing. If you are not using
an internally routed dropper post, install the
blank cover. If you are using an internally routed
dropper post, thread the cover with the hole in it
over your seat post cable housing. Do not secure
the cover until the post installation is complete.
ASSEMBLY
18.
Install the internal seat post cable routing cover.
Choose the blank if you are not using an internally
routed post. If you are using an internally routed
dropper post, thread the cover with the hole in it
over your cable housing before installing the post.
Secure it after the post installation is completed.
25.
Advertisement
