Troubleshooting; Rollers Not Heating - Royal Sovereign RSC-1650C Service Manual

Roll laminator
Hide thumbs Also See for RSC-1650C:
Table of Contents

Advertisement

2.1 Rollers Not Heating

CAUSES
1. Disconnected Heater Wire.
2. Defective T/Fuse.
3. Defective Bi-metal.
4. Defective Heater Assembly.
5. Defective Main PCB.
MEASURES
NOTE: Below steps require you to disassemble the Right, Left,
and/or Rear Covers. (Refer to the "Replacing Parts" section)
Follow the below steps in order.
1. Disconnected Heater Wire.
a) Check to make sure that the heater wire is connect to the Main PCB. Figure 1
2. Defective T/Fuse.
a) Use the multi-tester to check the continuity on the "Wire-T/Fuse".
If it fails replace the Wire-T/Fuse. Figure 2

2. Troubleshooting

(
RSC-1650H / HR Only
Heater Wires
Figure 1
23 ~ 29
30 ~ 36
37 ~ 42
Figure 2
)
WIRE-T/FUSE
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rsc-1650hRsc-1650hr

Table of Contents