2. Defective Heater Assembly
a) Replace the broken Heater Assembly. Figure 2
3. Main PCB is defective
a) Replace Main PCB.
2.3) Rollers Not Running
CAUSES
1. Emergency Switches are Active.
2. Pressure Plate is not in Proper Position.
3. Film is Jammed on the Rollers.
4. Main Motor Wires are Disconnected.
5. Defective Main PCB.
6. Defective Main Motor.
MEASURES
1. Emergency Switch is (are) Active.
a) Deactivate front and rear emergency switches.
2. Pressure Plate is not in Proper Position.
a) Ensure that the Pressure Plate is in the proper position and the
Pressure Plate switch is active. Figure 1
3. Film is Jammed on the Rollers.
a) Carefully un-jam the film from the rollers.
Figure 2
Broken
Pressure Plate Switch
Figure 1
6