Table of Contents
Advertisement
Cleaning the Body of the laminator
1.To clean the machine body, dampen a cloth with water only and gently wipe the
machine clean.
Removing Adhesive Build Up
1. Remove the film from the laminator.
2. Use a damp (water only) cloth and a rubber gum eraser to remove the adhesive on the
Teflon (metal) and silicone rollers.
Note: Rub firmly but do not scrub the rollers vigorously as this may scratch the
surface. Do not use sharp metal objects, steel wool, or abrasives, as these
may also damage the rollers.
Lubrication
1. Drive chain and sprockets should be lubricated with either a light coat of gear lube or
heavy grease (lithium grease) after 6 months or 1000 hours of operation, whichever
comes first.
Symptom
Machine will not turn
on:
There is power, but
the rollers are not
turning after the
"RUN" button is
pressed:
Curled lamination:
RSC-1401CLTW /RSC-1651CLTW /RSC-1653P
12. MAINTENANCE
13. TROUBLESHOOTING
Cause
a. Power plug is not plugged in.
b. Power switch is in "0" (Off)
position.
c. Tripped circuit breaker.
d. Blown main power fuse.
a. Emergency switch(es) is (are)
engaged.
b. Paper guide is not installed
correctly.
c. Blown motor fuse.
a. Upward curl.
b. Downward curl.
a. Plug the power cord into
appropriate outlet.
b. Put the power switch to the "I"
(On) position.
c. Reset the circuit breaker.
d. Replace the fuse.
a. Disengage the emergency
switch(es).
b. Properly install the paper guide so
that the micro switch is activated.
d. Replace the motor fuse.
a. Loosen the top roll film tension.
b. Loosen the bottom roll film
tension.
13
Possible Solution
Advertisement
Table of Contents
