Table of Contents
Advertisement
Removing Adhesive Build Up
1. Remove the film from the laminator.
2. Use a damp (water only) cloth and a rubber gum eraser to remove the adhesive on the silicone rollers and any other
surfaces.
Note: Rub firmly but do not scrub the rollers vigorously as this may scratch the surface.
Do not use sharp metal objects, steel wool, or abrasives, as these may also damage the rollers.
Lubrication
1. Drive chain and sprockets should be lubricated with either a light coat of gear lube or heavy grease (lithium grease)
after 6 months or 1000 hours of operation, whichever comes first.
12. TROUBLESHOOTING
Sympton
Machine will not turn on:
There is power, but the rollers are
not turning after the "RUN" button
is pressed:
The unit is not heating up:
Curled lamination:
Cause
a. Power plug is not plugged in.
b. Power switch is in "0" (Off) position.
c. Tripped circuit breaker.
d. Blown main power fuse.
a. Emergency switch(es) is (are)
engaged.
b. Safety Sensor is blocked.
c. Blown motor fuse.
a. Did not raise the temperature.
a. Upward curl.
b. Downward curl.
11
Fremont 65H
Possible Solution
a. Plug the power cord into appropriate
outlet.
b. Put the power switch to the "I" (On)
position.
c. Reset the circuit breaker.
d. Replace the fuse.
a. Disengage the emergency switch(es).
b. Remove any material that may be
blocking the Safety Sensor.
d. Replace the motor fuse.
a. Raise the temperature.
a. Loosen the top roll film tension.
b. Loosen the bottom roll film tension.
Advertisement
Table of Contents
