SECTION 8 – SETTING SharpArcE CONTROL
8-1. Selecting And Adjusting SharpArcE Control
> Process
Sequence
SharpArc
Card
1
> SharpArc
OM-201 396 Page 46
> Prg 1
Pulse
035" Steel
Argon – Oxy
Mode
Select
>SharpArc
Process
0
Sequence
Card
Parameter
Select
SharpArc
> 0
Set Desired Value
Increase/Decrease
1
SharpArc
SharpArc is used to adjust arc
cone width and arc characteristics.
Use mode select button to move >
to select SharpArc. Use Display
Control to adjust Arc setting.
SharpArc setting range is from 0
to 20. The factory default is set at
zero (0). When Arc value is
increased toward 20, the arc cone
narrows and the weld puddle
becomes less fluid.
SharpArc
SharpArc
> 10
> 10
Parameter
Select
> SharpArc
10