Section 7 − Setting Sequence Parameters - Miller Axcess E Dual Owner's Manual

SECTION 7 − SETTING SEQUENCE PARAMETERS
7-1. Sequence Parameters In A Program
Preflow
Time
Preflow
Trigger
Pressed
OM-248965 Page 36
Sequence
Volts/Trim
1. Preflow
10.0-44.0/
2. Start
0-99
10.0-44.0/
3. Crater
0-99
4. Retract
5. Postflow
X = Setting available.
Start
Time
Weld
Start
Parameters
IPM Seconds
Off-10.0
40-1400/
Off-10.0
0-99
40-1400/
Off-10.0
0-99
50-500
Off-10.0
Off-10.0
Weld
Crater
Time
Crater
Trigger
Released
.
For more information on
Sequence mode, see Feeder
Set Up Push Button in Section
6-9.
Weld Time can only be set by using
the HTML pages.
If time is set to Off in Weld
sequence, welding continues until
gun trigger is released.
If time is set to zero in any timed
sequence except
sequence is skipped.
.
Maximum IPM may actually
be lower depending on wire
size and gas combination.
Additional sequence
changes can be made using the
HTML pages. Refer to the HTML
pages for additional information.
Retract
Time
Postflow
Time
Time
Sequence
Postflow
Retract
End
Weld, the
set up