Exiting The Control Menu; Section 12 - Maintenance & Troubleshooting; Routine Maintenance; Blowing Out Inside Of Unit - Miller Auto Invision II Owner's Manual

11-7. Exiting The Control Menu

Access
Control
Display
Press Mode
Select
SECTION 12 – MAINTENANCE & TROUBLESHOOTING

12-1. Routine Maintenance

3 Months
Replace
damaged or
unreadable
label.
Repair or
replace cracked
cables and cords.
Clean and
tighten weld
terminals.

12-2. Blowing Out Inside Of Unit

AutoConfig
Retract
ShrpStrt
> Exit
Repair or
replace
cracked
cables.
1
Exit Cntrl
Menu Now
Press
Y Disconnect power
before maintaining.
6 Months
Blow out
inside.
1 Exit Control Menu Display
Allows the user to leave the control
menu.
.
Maintain more often
during severe conditions.
Replace
cracked
torch body.
Y Do not remove case when
blowing out inside of unit.
To blow out unit, direct airflow
through front and back louvers as
shown.
801 914
OM-201 396 Page 69