Selecting Teach Point Wire Feed Speed For Pulse Welding Program - Miller Auto Invision II Owner's Manual

6-3. Selecting Teach Point Wire Feed Speed For Pulse Welding Program

> Process
Sequence
SharpArc
Card
Mode
Select
OM-201 396 Page 38
1
> Prg 1
Pulse
035" Steel
Argon – Oxy
Parameter
Select
3
Teach On
> 400 IPM
28.1 Vpk
340 Apk
Parameter
Select
1
When unit is first turned On,
Process is the default screen, at
2
other times use mode select button
to select Process.
2
Use parameter select button to
Pulse
select Teach.
035" Steel
Use increase/decrease buttons to
select On.
> Teach Off
3
The parameters associated with
this wire feed speed teach point can
be modified. The wire feed speed
Increase/ value itself cannot be changed from
Decrease the set point.
To set or adjust teach point parame-
ters, go to Section 6-4.
> Teach On
400 IPM
28.1 Vpk
340 Apk
Process Display
Teach Display
IPM (Teach Point)