Adjusting The Volume; Adjusting The Squelch; Setting The Backlight - Uniden UBC125XLT Owner's Manual

Adjusting the Volume

1. Press SCROLL CONTROL; The volume level indicator and
battery voltage display.
2. Turn SCROLL CONTROL to adjust the volume level from 0
to 15.
3. Press SCROLL CONTROL to set the volume.
To exit Volume Level mode, press SCROLL CONTROL
4.
again or wait 10 seconds to return to the previous mode.

Adjusting the Squelch

1. Press Func, then press SCROLL CONTROL. The squelch
level indicator and battery voltage appears.
2. Turn SCROLL CONTROL to change the squelch level from
0 to 15.
3. Turn SCROLL CONTROL until the audio mutes. If the
scanner picks up unwanted partial signals or very weak
transmissions, increase the Squelch setting to increase the
signal level required to open squelch. To listen to a weak or
distant station, decrease the Squelch setting.
4. Press SCROLL CONTROL to set the desired level and return
to the previous mode.

Setting the Backlight

Press to turn on the backlight on and off .
1. Press Func and
From this menu, scroll to Set Backlight from the
2.
submenus. Press SCROLL CONTROL.
30
to view the Display/Charge menu.