58
REGULAR CHECKS AND MAINTENANCE WORK
6. Fill oil through the oil filling opening on the top side of
the tank.
7. Let the engine run for approx. 5 min. and check the oil
level again.
A Should dirt deposits be in the hydraulic tank, remove
with the help of a clean cloth and light oil.
Hydraulic oil volumes
BReplacing Hydraulic Pilot Filter Element
To avoid personal injury:
A Before replacing the element, wait long enough
for the hydraulic fluid to cool down.
1. Remove the arch cover.
2. Remove the hydraulic oil tank cover.
3. Remove the pilot filter case from the head cover.
4. Wrench and pull out the element downward.
5. Replace the O-ring with a new one.
6. Apply a light coating of clean hydraulic oil to the O-ring
and fit it to the case firmly. Be careful not to scratch the
O-ring.
7. Install the case to the head cover firmly.
8. Let the engine run for approx. 3 minutes.
9. Check the oil level of hydraulic oil tank.
(1) Head cover
(2) Element
(3) O-ring
(4) Case
EVERY 1000 SERVICE HOURS OR ONCE A
YEAR
BReplacing Air Filter Element
Open the engine cover and remove the dust cover.
Take out outer element and inner element (safety
element).
Replace inner and outer element.
55 L
Installing the dust cover, be sure to its TOP mark (arrow)
faces upwards.
(1) Outer element
(2) Inner element (Safety element)
(3) Case
(4) Dust cover
(5) Clamps
A Shorten the replacement period if using in a place
EVERY 1500 SERVICE HOURS
BChecking Fuel Injection Nozzle(Injection
Consult your local KUBOTA Dealer for this service.
EVERY 2000 SERVICE HOURS
Do all 50, 200, 250, 500 and 1000 hour servicing at the
same time.
BChanging Front Idler and Track Roller Oil
A Contact your KUBOTA dealer for details.
BChecking Alternator and Starter Motor
A Contact your KUBOTA dealer for details.
exposed to lots of dust or sandy areas.
Pressure)