Example Xmodem Firmware Upload Using Hyperterminal; Figure 21-17 Example Xmodem Upload; Uploading Configuration File Via Console Port; Figure 21-18 Menu 24.7.2 As Seen Using The Console Port - ZyXEL Communications VES-1000 Series User Manual

VES-1000 Series Ethernet Switch
After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on your computer.
2.
Follow the procedure as shown previously for the HyperTerminal program. The procedure for other serial
communications programs should be similar.
21.4.9

Example Xmodem Firmware Upload Using HyperTerminal

Click Transfer, then Send File to display the following screen.
After the firmware upload process has completed, the VES will automatically restart.
21.4.10

Uploading Configuration File Via Console Port

Select 2 from Menu 24.7 – System Maintenance – Upload Firmware to display Menu 24.7.2 — System
1.
Maintenance — Upload System Configuration File. Follow the instructions as shown in the next screen.
21-12

Figure 21-17 Example Xmodem Upload

Menu 24.7.2 — System Maintenance — Upload System Configuration File
To upload system configuration file:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atlc" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
router.
Warning:
1. Proceeding with the upload will erase the current
configuration file.
2. The router's console port speed (Menu 24.2.2) may change
when it is restarted; please adjust your terminal's speed
accordingly. The password may change (menu 23), also.
3. When uploading the DEFAULT configuration file, the console
port speed will be reset to 9600 bps and the password to
"1234".
Do You Wish To Proceed:(Y/N)

Figure 21-18 Menu 24.7.2 as seen using the Console Port

Type the firmware file's
location, or click Browse to
look for it.
Choose the Xmodem protocol.
Then click Send.
Firmware and Configuration File Maintenance