Example Xmodem Firmware Upload Using Hyperterminal; Uploading Configuration File Via Console Port; Figure 185 Menu 24.7.1 As Seen Using The Console Port; Figure 186 Example Xmodem Upload - ZyXEL Communications P-202H V2 User Manual

Figure 185 Menu 24.7.1 As Seen Using the Console Port

To upload system firmware:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atur" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the router.
Warning: Proceeding with the upload will erase the current system
firmware.
2 After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on
your computer. Follow the procedure as shown previously for the HyperTerminal
program. The procedure for other serial communications programs should be similar.

29.4.9 Example Xmodem Firmware Upload Using HyperTerminal

Click Transfer, then Send File to display the following screen.

Figure 186 Example Xmodem Upload

After the configuration upload process has completed, restart the ZyXEL Device by entering
"atgo".

29.4.10 Uploading Configuration File Via Console Port

1 Select 2 from Menu 24.7 – System Maintenance – Upload Firmware to display Menu
24.7.2 - System Maintenance - Upload System Configuration File. Follow the
instructions as shown in the next screen.
Chapter 29 Firmware and Configuration File Maintenance
Menu 24.7.1 - System Maintenance - Upload System Firmware
Do You Wish To Proceed:(Y/N)
P-202H Plus v2 User's Guide
282