Yanmar 6LY3 series Service Manual page 336

TROUBLESHOOTING
DTC Fault Code
DTC / FMI
1. Key switch ON
2. Input signal voltage is above 4.8V
P0195/3
3. 0.5 seconds
4. CHECK ENGINE on the TELEFLEX display
1. Key switch ON
2. Input signal voltage is below 0.2V
P0195/4
3. 0.5 seconds
4. CHECK ENGINE on the TELEFLEX display
Fail Mode
Limited Operation
Fail Release
Remarks
Fault
DTC / FMI
1. Open circuit on the wire harness or short to high voltage over 5V
P0195/3 2. Sensor failure
3. ECU failure
1. Wire harness short to ground
P0195/4 2. Sensor failure
3. ECU failure
Troubleshooting Procedure
See Troubleshooting the Temperature Sensor on page 13-40.
13-46
1. Condition, 2. Fault, 3. Time to Detect, 4. Display
Engine takes the following oil temperature as a default:
90°C (194°F)
No limited operation
Yes
When the input signal voltage goes to normal range (0.2 - 4.8V)
—
© 2007 Yanmar Marine International
Troubleshooting by DTC Fault Codes
Probable Cause
6LY3 Service Manual
Check Point
Wire harness sensor
Wire harness sensor