ashtech ZY-12 Information Supplement page 61

To access this function highlight EDIT WAYPOINT, and press [e] (Figure
3.31).
To edit a waypoint proceed as follows:
1. With the waypoint number highlighted, cycle through the list of waypoints,
using the up and down arrows, until the desired waypoint is displayed.
Alternatively, using the numbered keys, enter the waypoint number.
2. Press the right arrow to move the cursor to the name field and to bring up the
alphanumeric conversion table at the bottom of the screen. Enter the waypoint
name.
3. Using the down arrow, move to the next field and overwrite the latitude
(including N or S) and the longitude (including E or W). From the data field,
press [e] to save the waypoint information. Note that the up and down arrows
allow you to move from one field to the other, while the left and right arrows
allow you to move from one character to the other.
The EDIT WAYPOINT option has three additional functions available: CLEAR,
HERE, and COPY FROM.
The CLEAR function allows you to clear the information of a waypoint. To use this
function, do the following:
1. Select a waypoint with the waypoint number highlighted and using the up and
down arrows, or the numbered keys.
2. Using the cursor, highlight the CLEAR field and press the [e] key. The name
of the waypoint clears and the latitude and longitude reset to zero.
3. From the data field, press the [e] key to save the changes. If desired, you can
edit a new waypoint.
Screen Descriptions
Figure 3.31. Edit Waypoint
55