Operation Of The Isatphone Pro - Beam IsatDock DRIVE User Manual

Operation of the IsatPhone Pro

Prepare the Inmarsat IsatPhone Pro
Ensure that the IsatPhone Pro Handset has the
latest compatible firmware installed. For more
information visit:
www.beamcommunications.com/support/
isatdock
Starting Up
1. Retract the antenna on the IsatPhone
Pro handset.
2. Place the IsatPhone Pro as per instructions
"Docking & Undocking" on page 21.
3. Turn vehicle ignition on. The IsatPhone
Pro will automatically power and the
handset will then start to initialise followed
by a 3 tone rising beep when a successful
connection has been made between the
docking station and the IsatPhone Pro.
4. Wait for the IsatPhone handset to register on
the Inmarsat network. The STATUS LED on
the docking station will turn green when a
successful registration has taken place.
5. You are now ready to make and receive calls.
22
NOTE:
If the IsatPhone Pro is removed from the dock during
a call, the call will drop out during this transition.
NOTE:
One common cause for connection failure is a flat
IsatPhone battery which prevents the IsatPhone
from turning ON. In these instances the docking
station will attempt to charge the Isatphone
handset while it is switched OFF, until enough
charge is present for the IsatPhone to turn ON.
This charging period can take up to 20 minutes
depending on how flat the battery.
Pro handset
The IsatDock DRIVE provides charging power to
the IsatPhone handset via its USB connector.
The IsatPhone battery is a lithium-ion cell which
has a safety temperature range whilst charging.
This range is from 0 to 45 degrees Celsius (32 to
113 degrees Fahrenheit).
Due to the increased heating effects on the
IsatPhone handset whilst it is docked and being
charged, it is ideal for the ambient temperature
to be at least 15 degrees below the 45
limit for the handset to charge the battery whilst
docked. If the battery temperature exceeds this
limit, then the IsatPhone may cease charging until
the temperature is reduced.
C upper
o