Isatdock Lite Usage; Docking & Undocking The Isatphone Pro Handset; Operation Of The Isatphone Pro - Beam IsatDock LITE User Manual

IsatDock LITE Usage

Docking & undocking the IsatPhone
Pro handset
To place the IsatPro Phone into the docking unit, both
the ' c overs' on the external antenna connectors and
the USB/Audio connectors need to be opened.
1. The antenna 'door' must be placed at 90
degrees to the antenna connector cavity and
run parallel to the top edge of the phone.
2. The 'cover' in the base of the phone should be
in the fully opened position.
2
3. To dock the handset, align the IsatPhone with
the phone tray and slide the handset down
until it seats flush to the bottom of the tray.
4. Swing the phone down into the cradle
by applying pressure to the top of the
handset. An audible 'click' is heard when
the phone is in the docked position.
5. To remove the handset from the cradle,
press the EJECT button at the top of the
docking station. The dock will swing out
1
and the handset can be removed.
Eject Button

Operation of the IsatPhone Pro

Prepare the Inmarsat IsatPhone Pro
Ensure that the IsatPhone Pro Handsethas the
latest compatible firmware installed. For more
information visit:
www.beamcommunications.com/support/
isatdock
ISatDock LITE - Installation & User Manual
Starting Up
1. Retract the antenna on the IsatPhone
Pro handset.
2. Place the IsatPhone Pro as per instructions
"Docking & Undocking" on page 20.
3. Turn vehicle ignition on. The IsatPhone Pro
will automatically power up followed by a
rising beep, once the docking station has
successfully synchronized with the IsatPhone.
4. Wait for the IsatPhone handset to register on
the Inmarsat network. The STATUS LED on
the docking station will turn green when a
successful registration has taken place.
5. You are now ready to make and receive calls.
NOTE:
If the IsatPhone Pro is removed from the dock during
a call, the call will drop out during this transition.
19