Cleaning The Solution Filter - COMAC SIMPLA 55BT Use And Maintenance Manual

Clean the hopper as described in the "AT THE END OF THE WORK" paragraph
4. Check there are no wires, bits of plastic or anything else at the ends of the brushes; these objects
could stop the brushes from rotating freely. If the brushes are not clean:
5. Loosen the closure element (1)
6. Release the splash guard (2)
7. Remove the idle hubs (3) that support the brushes (4)
8. Remove the brushes (4), clean them with a jet of water, then reassemble them. Check the bristles are
not worn; in the event of excessive wear, replace the brushes (the bristles should be at least 10mm
long)
9. Reassemble the splash guards (2), inserting first the hubs (3) in the toothed seat of the brushes and
tightening the closure element (1)
Take care not to mix up the brushes, the blue brush should always be placed in the rear idle hub.
Take care how the brushes are mounted, the assembly is correct if the direction of the bristles form an X
looking from above.
WARNING: you are advised to always wear protective gloves in order to avoid the
risk of serious injury to your hands

7. CLEANING THE SOLUTION FILTER

1. Turn off the tap by means of the lever (1)
2. Loosen the cap (2) of the solution filter
3. Remove the filter and rinse with a jet of water
4. Reassemble the filter and tighten the cap
5. Turn on the tap beneath the symbol (1)
WARNING: you are advised to always wear protective gloves in order to avoid
the risk of serious injury to your hands
DAILY MAINTENANCE
28
2
3
2
1
4
1
2