Overflow Device - COMAC SIMPLA 55BT Use And Maintenance Manual

7. Release the lever (3) and lower the base. In the case of an automatic machine, lower the key (7).
8. Lower the squeegee, rotating the lever (4) anticlockwise. If the machine is automatic, use the key (5);
when you have turned it as far as it will go, the suction motor will switch on. To switch off the suction
motor, turn the key to position "0" once the work is finished.
9. Check the brake (6) is off.
10. Adjust the flow of detergent by means of the lever (7) for versions without CDS, or the solution flow
adjustment knob (8) and (9).
11. Press the "man present" levers (7) to activate the brushes; the machine will begin to move. During the
first metres, check there is sufficient solution and that the squeegee dries perfectly.
12. The machine will now begin to work efficiently until the battery is flat or the cleaning solution finishes.

2. OVERFLOW DEVICE

The machine is fitted with a float which intervenes when the recovery tank is full, causing the suction tube
to close. In this case, it is necessary to empty the recovery tank, removing the cap of the rear drainage
hose.
ATTENTION: this operation must be carried out using gloves to protect against
contact with dangerous solutions
WORK
23
7
5
6
4
3
7
8
9
7