Disassembling And Cleaning The Squeegee; Disassembling The Brush (B Versions); Disassembling The Brush (Bs Versions) - COMAC SIMPLA 55BT Use And Maintenance Manual

4. DISASSEMBLING AND CLEANING THE SQUEEGEE

Check the squeegee is always clean, for better drying results.
To clean it you must:
1. Turn main switch key anticlockwise to position "0", and remove the key, for the electric versions
unplug the machine from the mains, and engage the parking brake.
2. remove the tube (1) from the squeegee
3. remove the squeegee, pushing the plate (2) to the left in order to release the squeegee small column
from its seat
4. pull the squeegee to the right until the left-hand small column is released from its seat
5. carefully clean the inside of the squeegee and its suction nozzle
6. carefully clean the squeegee rubbers
7. reassemble all the elements

5. DISASSEMBLING THE BRUSH (B VERSIONS)

1. Engage the parking brake and turn the key switch to position "0 "
2. Raise the base, using the lever
3. With the base up, rotate the brush until it comes out of the brush-holder plate seat, as shown in the
figure. The figure shows the rotation direction to release the right-hand brush; for the left-hand one,
rotate in the opposite direction
4. Always check the bristles for signs of wear. You are advised to replace the brushes when the bristles
are less than 15mm long
ATTENTION: this operation must be carried out using gloves to protect against
contact with dangerous solutions

6. DISASSEMBLING THE BRUSH (BS VERSIONS)

To remove the brushes:
1. Turn the key anticlockwise to "OFF" (1)
2. stop the machine moving by applying the brake lever (2)
3. insert the blocking pin (3) in the holes of the brake handle to prevent the lever slipping
ATTENTION: do not leave the machine on sloping or wet floors, and check the
parking brake is correctly applied
DAILY MAINTENANCE
27
1
2
3 1
2