Daily Maintenance; Cleaning The Recovery Tank; Cleaning The Suction Filter; Cleaning The Suction Tube Filter - COMAC SIMPLA 55BT Use And Maintenance Manual

1. CLEANING THE RECOVERY TANK

1. Disconnect the tube (1) from its seat, unscrew the drainage cap and empty the recovery tank.
ATTENTION: Before performing any maintenance, remove the keys from the
panel and disconnect the battery connector of the machine.
WARNING: this operation must be carried out wearing gloves to protect
against contact with dangerous solutions.
2. Engage the parking brake.
3. Lift the brush head body and the squeegee body off the ground.
4. Raise the cap (2) until the hook is secured to the prop (3) of the recovery tank.
5. Clean and rinse the recovery tank and the suction pipe (connecting pipe between the squeegee and
the tank).
6. Reposition the cap on the drainage tube and lower the suction cap. To lock the prop (3) just slightly
raise the cap, release the prop (3) and lower the cap up to close it.

2. CLEANING THE SUCTION FILTER

1. Turn the main switch key anticlockwise to position "0" and remove the key, for the electric versions
unplug the machine from the mains.
2. Apply the parking brake and block the handle with the pin, inserting it in the lever holes.
3. Lift the cap until the hook is secured to the recovery tank prop.
4. Remove the suction filter protection (1) by rotating it clockwise
5. Remove the suction filter (2) from its seat
6. Use a jet of water to clean the walls and base of the filter
7. reassemble all the elements
WARNING: you are advised to always wear protective gloves in order to avoid
the risk of serious injury to your hands

3. CLEANING THE SUCTION TUBE FILTER

1. Engage the parking brake and turn the key switch to position "0 "
2. Check the recovery tank is empty (if necessary, empty it).
3. Raise the suction cover and block it as indicated in the previous paragraph
4. Rotate the inner filter (1) and remove it
5. Carry out the cleaning operations carefully
6. reassemble all the elements
ATTENTION: These operations must be carried out using gloves to protect
against contact with dangerous solutions

DAILY MAINTENANCE

PERFORM ALL MAINTENANCE OPERATIONS IN SEQUENCE
26
1
2
3
2
1
1