Installing Your Phone; Test The Connection - Uniden XDECT SSE35 Series Owner's Manual

Charge the battery
1. Unpack all handsets, battery packs, and battery
covers. If you need to remove a cover, press in on
the notch and slide the cover down and off.
2. Line up the battery connector with the jack inside
the handset; the connector only fits one way.
3. Push the connector in until it clicks into place; tug
gently on the wires to make sure the battery is
securely connected.
4. Replace the battery cover and slide it into place.
5. Use an AC adaptor to connect the power jack on the
base to a regular indoor (240V AC) power outlet. Connect any chargers the same
way.
6. Place a handset in the base with the display facing forward. If the battery icon
does not begin cycling through levels, reseat the handset or connect the base to a
different outlet. For 2 or more handsets, place each handset in a charger.
# Charge all handsets completely (about 15 hours) before using.
Connect the Telephone Cord
Use the telephone cord to connect the TEL LINE jack on the base to a standard
telephone wall jack.

test the Connection

1. Pick up the handset and press TALK/FLASH. The handset sounds a dial tone, and the
display shows Talk.
• If you don't hear a dial tone or the display says Check Tel Line, check the connection
between the base and the phone jack.
2. Make a quick test call. (Press TALK/FLASH to hang up.)
• If there's a lot of noise, check for interference (see page 29).
3. Test all handsets the same way. If you can't get a dial tone, move the handset closer
to the base.

InstallIng your phone

5