Step 3: Install Side Panels; Step 4: Install Anti-Tip Brackets - Monogram ZIRS36N LH Installation Instructions Manual

Step 3 • Side panels are required whenever the sides of the
Install
Side
Panels
• Side panels are not required when installed into an
• Side panel installation will be determined by the
• Side panels must be installed plumb.
Illustration A
1/4" Side Panels –
Insert end of side
panel into case trim.
Fasten with Velcro
strips included.
Standard 4" high toekick or trim to fit. Height
may vary depending on application.
Step 4
Install
Anti-Tip
Brackets
• Cut a 2" x 4" x 35" block and secure the block to
• Secure the bracket with wood block to the back wall
• Screws must penetrate at least one inch into vertical
• Gently push refrigerator into the opening with hands
10
product will be exposed and when installed between
frameless cabinets. See pages 3 and 4.
enclosure.
design of the side panel you have previously chosen.
23-9/16"
84"
Trim
2-9/16"
Top View
CAUTION WARNING
ANTI-TIP PRECAUTIONS
The refrigerator is top-heavy and must be secured to
prevent the possibility of tipping forward.
ATTENTION
PRECAUTIONS CONTRE LES BASCULEMENTS
Le réfrigérateur est beaucoup plus lourd en haut et
il faut le maintenir en place pour éviter la
possibilité de son basculement vers l'avant.
the mounting brackets provided using #12 or #14 wood
screws.
so that it is 84" (or your installation height) from the
finished floor. Use #12 or #14 wood screws. See
illustration.
wall studs.
against front corners.
Installation
36" Stainless Steel Refrigerators, Freezers
• If you choose to use 1/4" side panels, they should be
inserted into the case trim as illustrated. Fasten the
panels to the product with stick-on hook and loop
fastener strips before setting in place. See
illustration A.
• 1/2" to 3/4" side panels are normally set into place and
fastened to adjacent cabinetry or the back wall before
rolling the product into the opening. See illustration B.
Illustration B
1/2" to 3/4" Side
Panels – Leading
edge of side panel is
flush with cabinet
front. Fasten to the
back wall using a
cleat.
Top View
Standard 4" high toekick or trim to fit.
Height may vary depending on application.
Block
Brackets
Required
2 x 4 Cut
35" Length
Installation
Height
From Floor
Screws Mounted into
Vertical Wall Studs
Important Note: When the refrigerator is installed under a soffit
or if there is not enough height for this method of security,
brackets cannot be used. Proceed to step 5 to level the
refrigerator and then to step 6 to secure refrigerator to cabinets.
The refrigerator must be secured to prevent tipping.
24-3/4"
84"
3-3/4"
Soffit
Brackets
Not Required
Beneath a
Soffit
Height
From
Floor
to
Bottom
of Wood
Block
Side View
Mounting
Bracket