Step 9
Install
Soffit
Vent Top
• Separate the top and hinge side trim pieces by
• Install one end piece to unified top piece with 2
• Slip end of rubber dust gasket into end of top unified
• Reinstall end pieces to case trims. Push top piece up
• Whenever possible, place a level on the top trim.
• Mount the unified grille panel by dropping into slots
Step 10
Mount
Unified
Grille Panel
Into Trim On One End
removing side screws. Discard top piece, retain
screws.
original screws.
piece and slide trim towards the center. Engage the
second piece of gasket and continue sliding trim until
even with opposite ends.
against soffit or to installation height. Tighten screws
on both sides.
Adjust side trims until entire grille frame is level.
on the outside case trim.
ZUGSS Trim Kit
Slip Dust Gasket
Unified Stainless Steel Grille Panel
Slip Second Dust
Gasket Into Trim
Reinstall
Screws
19